OPTIMIZATION OF THE CUTTING PARAMETERS AFFECTING THE SURFACE ROUGHNESS ON FREE FORM SURFACES
Küçük Resim Yok
Tarih
2017
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Yildiz Technical Univ
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
This study aims to determine the optimal cutting parameters in order to achieve minimum surface roughness on free form surfaces. Frequently preferred Al 7075-T6 material was used. Free form surfaces on the material were machined in the CNC milling in order to determine the cutting conditions that provide the best surface roughness. An experiment list was created with the Taguchi L16 experiment design for cutting speed, feed rate, stepover and machining strategies. As a result of these experiments, the average surface roughness (Ra) values were measured. Signal-to-noise (S/N) ratios were determined in the Taguchi design, and the most important effect on the average surface roughness among the four factors was found to be the stepover according to the experimental results. In ANOVA analysis, step over was found the 95% confidence level in Ra value.
Açıklama
Anahtar Kelimeler
Al 7075-T6, cutting parameters, milling, Taguchi Method, surface roghness
Kaynak
Sigma Journal of Engineering and Natural Sciences-Sigma Muhendislik Ve Fen Bilimleri Dergisi
WoS Q Değeri
N/A
Scopus Q Değeri
Cilt
35
Sayı
2
