Yasar, NafizBoy, MehmetGunay, Mustafa2024-09-292024-09-2920172261-236Xhttps://doi.org/10.1051/matecconf/201711201018https://hdl.handle.net/20.500.14619/553521st Innovative Manufacturing Engineering and Energy International Conference (IManE and E) -- MAY 24-27, 2017 -- Iasi, ROMANIAAA7075 aluminum alloy has been very popular significantly interest in the production of structural components in automotive and aviation applications due to its high strength, low density, good plasticity and better machinability comparable to many metals. Particularly, final products must have uniformly high quality to ensure essential safety standards in the aircraft industry. The optimization of hole quality which can variable according to tool geometry and drilling parameters is important in spite of high machinability rate of AA7075 alloy. In this study, the effects of drilling parameters on average surface roughness (Ra) has been investigated in drilling of AA7075 with tungsten carbide drills. Machining experiments were performed with three different drill point angles and three different levels of cutting parameters (feed rate, cutting speed). The effects of drilling parameters on thrust force has been determined with ANOVA in %95 confidence level. Feed rate was determined as the most important factor on Ra according to ANOVA results. Moreover, it was shown that increasing feed rate leads to increase of Ra while increasing drill point angle leads to decrease of Ra. The optimum surface roughness was obtained with point angle of 130 degrees, cutting speed of 40 m/min and feed rate of 0.1 mm/rev, thereby the validity of optimization was confirmed with Taguchi method.eninfo:eu-repo/semantics/openAccessCutting ParametersTaguchi MethodDryConference Object10.1051/matecconf/2017112010182-s2.0-85023626171N/A112WOS:000579349600018N/A