Gungor, A.Incesu, A.2024-09-292024-09-2920212213-9567https://doi.org/10.1016/j.jma.2020.09.009https://hdl.handle.net/20.500.14619/4933In this study, four different Mg-Zn-Ca-Mn alloys were produced using gravity die casting method. Mn content was kept constant in all alloys, while Zn and Ca were added in two different ratios. Homogenization heat treatment was applied to all cast alloys and a specimen from each homogenized alloy was hot rolled. Microstructure, mechanical properties, and corrosion behavior of the homogenized and hot rolled alloys were investigated as comparatively. Following results were obtained; grain size decreased significantly with increasing Zn content, Zn promoted Ca2Mg6Zn3 phase formation, corrosion resistance increased with increasing Zn/Ca atomic ratio, hot rolling resulted in much higher tensile strength but much lower ductility and toughness. Among the homogenized and hot rolled alloys, ZXM300-h alloy (hot rolled ZXM300 alloy) with its 146 +/- 2.5 MPa yield strength, 229 +/- 3.7 MPa tensile strength,% 1.6 +/- 0.1 elongation and 0.029 mm/yr immersion corrosion rate exhibited the best mechanical properties and corrosion resistance to be used as a biodegradable alloy such as fracture bone plate material. (C) 2020 Published by Elsevier B.V. on behalf of Chongqing University.eninfo:eu-repo/semantics/openAccessBiodegradableMg alloysHot rollingArticle10.1016/j.jma.2020.09.0092-s2.0-850921164692531Q12419WOS:000634519800019Q1