Analysis and optimization of process parameters affecting on the tensile strength of pla and iron-reinforced pla samples fabricated by fused deposition modeling method

Basit Öğe Kaydı
dc.contributor.authorKuruoglu, Yasin
dc.contributor.authorAkgün, Mahir
dc.contributor.authorDemir, Halil
dc.date.accessioned2024-09-29T16:32:00Z
dc.date.available2024-09-29T16:32:00Z
dc.date.issued2023
dc.departmentKarabük Üniversitesien_US
dc.description.abstractThis study focuses on investigating the influence of printing parameters on the tensile strength of PLA and iron-reinforced PLA samples produced using FDM technology. Filament material (PLA and iron-reinforced PLA), infill ratio (20, 40 and 60%), layer thickness (0.1, 0.2 ve 0.3 mm), printing speed (40, 60 and 80 mm/s) and raster angle (30, 45 and 60°) were selected as process parameters. The experimental design was based on the Taguchi L18 index. Signal-to-Noise (S/N) ratio, variance analysis (Anova) and regression analyses were used to statistically analyze the tensile strength values obtained as a result of experimental measurements. The outcomes of this study show that the reinforcement to PLA material decreases the tensile strength and increases the % elongation. The maximum tensile strength was measured as 33.55 MPa at 60% infill rate, 0.3 mm layer thickness, 60 mm/s printing speed and 60° raster angle in PLA filament material, which is the optimum process parameters.en_US
dc.identifier.doi10.52795/mateca.1332694
dc.identifier.endpage80en_US
dc.identifier.issue2en_US
dc.identifier.startpage72en_US
dc.identifier.trdizinid1196624en_US
dc.identifier.urihttps://doi.org/10.52795/mateca.1332694
dc.identifier.urihttps://search.trdizin.gov.tr/tr/yayin/detay/1196624
dc.identifier.urihttps://hdl.handle.net/20.500.14619/11281
dc.identifier.volume4en_US
dc.indekslendigikaynakTR-Dizinen_US
dc.language.isoenen_US
dc.relation.ispartofİmalat Teknolojileri ve Uygulamaları (Online)en_US
dc.relation.publicationcategoryMakale - Ulusal Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.titleAnalysis and optimization of process parameters affecting on the tensile strength of pla and iron-reinforced pla samples fabricated by fused deposition modeling methoden_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

TR-Dizin İndeksli Yayınlar Koleksiyonu