The effect of mechanical properties and the cutting parameters on machinability of aisi 5140 steel cooled at high cooling rates after hot forging

Küçük Resim Yok

Tarih

2019

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Erişim Hakkı

info:eu-repo/semantics/openAccess

Özet

In this study, the effect of mechanical properties and cutting parameters (Cp) on the machinability of AISI 5140 steel cooled at high cooling rates after hot forging was investigated. The microstructural examinations and hardness measurements of the as-received AISI 5140 steel and the workpieces cooled in the oil and polymerized water after hot forging were performed. Turning process was conducted by using a coated ceramic tool at five different cutting speeds (Vc) (120, 150, 180, 210, and 240 m/min), four different feed rates (fn) (0.04, 0.08, 0.12, and 0.16 mm/rev), and four different depths of cut (ap) (0.4, 0.6, 0.8, and 1 mm) under dry machining conditions. SEM examinations of the cutting tools were also performed. It was seen from the results that the changing microstructure and hardness values had a significant effect on cutting forces (Fc) and surface roughness (Ra) from the Cp depending on cooling rate. While the highest Fc were reached in the workpiece with the highest hardness cooled in the polymerized water after hot forging, the lowest surface roughness (Ra) was obtained in the same workpiece.

Açıklama

Anahtar Kelimeler

Mühendislik, Elektrik ve Elektronik, Bilgisayar Bilimleri, Yazılım Mühendisliği, Mühendislik, Makine, Mühendislik, Jeoloji, Bilgisayar Bilimleri, Bilgi Sistemleri, Bilgisayar Bilimleri, Donanım ve Mimari, Mühendislik, Kimya

Kaynak

Politeknik Dergisi

WoS Q Değeri

Scopus Q Değeri

Cilt

22

Sayı

4

Künye