Optimization of Surface Roughness in Turning Mg2Si Particle Reinforced Magnesium

Basit Öğe Kaydı
dc.authoridAKGUN, Mahir/0000-0002-4522-066X
dc.contributor.authorAkgun, Mahir
dc.contributor.authorDemir, Halil
dc.contributor.authorCiftci, Ibrahim
dc.date.accessioned2024-09-29T16:06:50Z
dc.date.available2024-09-29T16:06:50Z
dc.date.issued2018
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, Mg2Si reinforced Mg alloy material was produced by adding 10 % Al12Si alloy ingot to Mg matrix by conventional casting method and then the melt was poured into a metal mould in cylindrical form. Machining tests were carried out on these cast alloys through single point turning method. Optimum machining conditions was aimed to be determined by investigating the effects of cutting parameters on surface roughness. For this purpose, the machining tests were performed without coolant on a CNC turning centre at four different cutting speeds (250, 350, 450 and 550 m/min), two different feed rates (0.1 and 0.2 mm/rev) and two different tool tip radii (0.4 mm ve 0.8 mm). The experimental design was conducted according to Taguchi's L8 orthogonal array. Machining experiments were carried out on CNC lathe under dry cutting conditions. ANOVA was used to determine the effect of cutting parameters on the surface roughness. According to the obtained analysis results, it was seen that the most influential parameters on surface roughness was feed rate by 57.6 %.en_US
dc.identifier.doi10.2339/politeknik.385481
dc.identifier.endpage650en_US
dc.identifier.issn1302-0900
dc.identifier.issn2147-9429
dc.identifier.issue3en_US
dc.identifier.startpage645en_US
dc.identifier.urihttps://doi.org/10.2339/politeknik.385481
dc.identifier.urihttps://hdl.handle.net/20.500.14619/7082
dc.identifier.volume21en_US
dc.identifier.wosWOS:000444156000017en_US
dc.identifier.wosqualityN/Aen_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isotren_US
dc.publisherGazi Univen_US
dc.relation.ispartofJournal of Polytechnic-Politeknik Dergisien_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectMg alloyen_US
dc.subjectsurface roughnessen_US
dc.subjectTaguchi methoden_US
dc.subjectAnovaen_US
dc.titleOptimization of Surface Roughness in Turning Mg2Si Particle Reinforced Magnesiumen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu