Optimization of Honing Parameters for Renewal of Cylinder Liners

Basit Öğe Kaydı
dc.authoridKORKMAZ, Mehmet Erdi/0000-0002-0481-6002
dc.contributor.authorGunay, Mustafa
dc.contributor.authorKorkmaz, Mehmet Erdi
dc.date.accessioned2024-09-29T16:11:31Z
dc.date.available2024-09-29T16:11:31Z
dc.date.issued2017
dc.departmentKarabük Üniversitesien_US
dc.description.abstractThis study presented the optimization of honing parameters for surface roughness in plateau honing process used for renewal of engine cylinders. The honing experiments were performed based on Taguchi L-9 orthogonal array. The honing parameters directly affected on surface roughness (Ra) were determined as linear speed (m/min), grain size and number of stroke with three different levels. These levels were adjusted by considering honing industry and investigations on honing process. The results of variance analysis showed that the most important factor on surface roughness is the grain size while number of stroke has insignificant effect. Finally, an optimization study has been performed with the smaller the better method and then confirmation experiment has been conducted. The results have shown that the optimum conditions for better surface roughness were determined as feed rate of 10 m/min, grain size of 220 and stroke number of 6 according to analysis of signal-to-noise (S/N) ratios under these cutting conditions. According to confirmation experiment, the difference between experiment and the calculated value was determined as 2.5%. Thus, the optimum levels of honing parameters for Ra were confirmed as confident in renewal of engine cylinders.en_US
dc.description.sponsorshipScientific Research Project Unit of Karabuk University [KBU-BAP-14/1-YL-020]en_US
dc.description.sponsorshipThis study is supported by Scientific Research Project Unit of Karabuk University (KBU-BAP-14/1-YL-020) and the authors express their appreciation for this support.en_US
dc.identifier.endpage119en_US
dc.identifier.issn2147-1762
dc.identifier.issue1en_US
dc.identifier.startpage111en_US
dc.identifier.urihttps://hdl.handle.net/20.500.14619/8504
dc.identifier.volume30en_US
dc.identifier.wosWOS:000396686500009en_US
dc.identifier.wosqualityN/Aen_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherGazi Univen_US
dc.relation.ispartofGazi University Journal of Scienceen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectHoningen_US
dc.subjectSurface roughnessen_US
dc.subjectOptimizationen_US
dc.subjectTaguchi methoden_US
dc.titleOptimization of Honing Parameters for Renewal of Cylinder Linersen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu