Tribological properties of boronized ferrous based PM journal bearings

Basit Öğe Kaydı
dc.contributor.authorUnlu, Bekir Sadik
dc.contributor.authorYilmaz, Selim Sarper
dc.contributor.authorKurgan, Naci
dc.contributor.authorVarol, Remzi
dc.date.accessioned2024-09-29T16:11:24Z
dc.date.available2024-09-29T16:11:24Z
dc.date.issued2015
dc.departmentKarabük Üniversitesien_US
dc.description.abstractFerrous based PM (powder metallurgical) materials are widely used in journal bearings since they provide a good tribological performance. These bearings are self-lubricating and can be used in places where lubricating is not possible. This also applies to the shaft material which shows adhesive wear. Tribological properties can be improved and adhesive wear can be decreased by boronizing. In this study, tribological properties of ferrous based boronized and non-boronized Fe-graphite, FeCu-graphite and CuSnFe-graphite bearings manufactured by PM method have been determined and compared. Boronizing treatment was carried out at 950 degrees C for 4 hours. The SAE 1050 steel shaft was used as counter abrader. Experiments were carried out at 20 N loads and 1500 rpm every 30 minutes for 2.5 hours.en_US
dc.identifier.endpage266en_US
dc.identifier.issn0025-5300
dc.identifier.issue3en_US
dc.identifier.startpage259en_US
dc.identifier.urihttps://hdl.handle.net/20.500.14619/8410
dc.identifier.volume57en_US
dc.identifier.wosWOS:000350985300012en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherCarl Hanser Verlagen_US
dc.relation.ispartofMaterials Testingen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectTribologyen_US
dc.subjectboronizingen_US
dc.subjectpowder metallurgyen_US
dc.subjectsinter Fe bearingen_US
dc.titleTribological properties of boronized ferrous based PM journal bearingsen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu