Effects of Filling Percentage on Mechanical Properties of PLA and PET Materials

Basit Öğe Kaydı
dc.contributor.authorEvlen, Hatice
dc.contributor.authorOzdemir, Merve Ayfer
dc.contributor.authorCaliskan, Aydin
dc.date.accessioned2024-09-29T16:06:51Z
dc.date.available2024-09-29T16:06:51Z
dc.date.issued2019
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, it is aimed to design a printer which has fused deposition technology and determine experimentally the effect of infill percentage on the mechanical properties with samples produced on the printer. A Cartesian type and open source three dimensional printer was modelled. Mechanical test samples were printed at 10, 20, 30, 40 and 50% infill percentage of PET and PLA materials using a three-dimensional printer manufactured as a prototype. Using the obtained samples, uniaxial tensile tests, hardness and surface roughness values were measured. As a result of the measurements, the hardness values of PET and PLA materials were directly related to the infill percentage of the material, and the hardness of the materials increased as the filling percentage increased. It was observed that roughness and tensile values of PLA and PET materials were inversely related to each other and roughness and tensile strength values were observed in the opposite direction from 30% infill percentage to 10% and 20% infill percentage.en_US
dc.identifier.doi10.2339/politeknik.426413
dc.identifier.endpage1037en_US
dc.identifier.issn1302-0900
dc.identifier.issn2147-9429
dc.identifier.issue4en_US
dc.identifier.startpage1031en_US
dc.identifier.urihttps://doi.org/10.2339/politeknik.426413
dc.identifier.urihttps://hdl.handle.net/20.500.14619/7089
dc.identifier.volume22en_US
dc.identifier.wosWOS:000489153800027en_US
dc.identifier.wosqualityN/Aen_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isotren_US
dc.publisherGazi Univen_US
dc.relation.ispartofJournal of Polytechnic-Politeknik Dergisien_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectInfill percentageen_US
dc.subjectPETen_US
dc.subjectPLAen_US
dc.subjectsurface roughnessen_US
dc.subjecthardnessen_US
dc.titleEffects of Filling Percentage on Mechanical Properties of PLA and PET Materialsen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu