CUTTING TOOL GEOMETRY IN THE DRILLING OF CFRP COMPOSITE PLATES AND TAGUCHI OPTIMISATION OF THE CUTTING PARAMETERS AFFECTING DELAMINATION

Küçük Resim Yok

Tarih

2018

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Yildiz Technical Univ

Erişim Hakkı

info:eu-repo/semantics/closedAccess

Özet

It is possible to improve the hole quality by reducing the delamination which occurs in the drilling of carbon fibre reinforced plastic (CFRP) composite plates. For this study, carried out under dry machining conditions, the parameters included three different cutting speeds, three different feed rates and drill geometry involving three different point angles. The Taguchi L-9 orthogonal array experimental design was selected and the optimum cutting parameters and drill geometry for reducing the damage factor to a minimum were determined. The optimum test conditions were achieved using the parameter combination of 118 degrees point angle, 30 m/min cutting speed and 0.06 mm/rev feed rate (A1B1C1). In addition, variance analysis (ANOVA) was conducted to determine the effect rate of the parameters on the damage factor. The variable having the greatest effect on the damage factor was found to be the point angle (47.66%), followed by the cutting speed (24.44%) and feed rate (19.82%). The conditions for minimising delamination damage in the drilling of the CFRP plates were optimised successfully by using the Taguchi test design.

Açıklama

Anahtar Kelimeler

CFRP composite, drilling, delamination, design of experiments, ANOVA

Kaynak

Sigma Journal of Engineering and Natural Sciences-Sigma Muhendislik Ve Fen Bilimleri Dergisi

WoS Q Değeri

N/A

Scopus Q Değeri

Cilt

36

Sayı

3

Künye