Wear Properties of Titanium and Ti6Al4V Titanium Alloy by Mechanical Milling

Basit Öğe Kaydı
dc.authoridTEKELI, SULEYMAN/0000-0001-9826-6875
dc.contributor.authorOzyurek, Dursun
dc.contributor.authorTekeli, Suleyman
dc.date.accessioned2024-09-29T16:06:12Z
dc.date.available2024-09-29T16:06:12Z
dc.date.issued2011
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, wear characteristics of titanium and titanium alloyed materials produced with mechanical alloying/milling (MA/MM) method were studied. In production of titanium and titanium alloyed materials, sponge titanium, gas atomised titanium powder and pre-alloyed Ti6Al4V alloy powder were used. The produced materials were characterised by scanning electron microscope, optical microscope, X-rays diffractometer (XRD) and EDS. The wear tests were carried out on a pin-on-disc type wear device under three different loads (15-30-45 N), four different sliding distances (500-1000-1500-2000 m) and a sliding speed of 1 ms(-1). The results showed that no porosity was found on the gas atomised titanium and the Ti6Al4V alloy while very low amounts of micro porosity were formed on the sponge titanium samples. EDS analysis, on the other hand, revealed some Fe contamination on the materials, arising from the milling environment. It was seen that the hardness values of the samples produced from the gas atomised titanium powder were higher either than the samples produced from the sponge titanium, or the samples produced from the Ti6Al4V alloy. The fact that the wear losses obtained for the samples produced from the TiAl4V and gas atomised titanium powders were lower when compared to the sponge titanium. This was considered as the result of porous structure of sponge titanium.en_US
dc.identifier.doi10.1515/HTMP.2011.026
dc.identifier.endpage180en_US
dc.identifier.issn0334-6455
dc.identifier.issue1-2en_US
dc.identifier.scopus2-s2.0-84255175910en_US
dc.identifier.scopusqualityQ3en_US
dc.identifier.startpage175en_US
dc.identifier.urihttps://doi.org/10.1515/HTMP.2011.026
dc.identifier.urihttps://hdl.handle.net/20.500.14619/6704
dc.identifier.volume30en_US
dc.identifier.wosWOS:000294207300026en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherWalter De Gruyter & Coen_US
dc.relation.ispartofHigh Temperature Materials and Processesen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectTitanium alloyen_US
dc.subjectwear propertiesen_US
dc.titleWear Properties of Titanium and Ti6Al4V Titanium Alloy by Mechanical Millingen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu