Effect of magnesium addition on wear behaviour of Al-70 vol.-%Al2O3p composites

Basit Öğe Kaydı
dc.authoridCimenoglu, Huseyin/0000-0002-9921-7108
dc.authoridAHLATCI, Hayrettin/0000-0002-6766-4974
dc.authoridCandan, Ercan/0000-0002-0610-5044
dc.contributor.authorAhlatci, H
dc.contributor.authorKarakas, MS
dc.contributor.authorCandan, E
dc.contributor.authorÇimenoglu, H
dc.date.accessioned2024-09-29T16:05:07Z
dc.date.available2024-09-29T16:05:07Z
dc.date.issued2003
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, dry sliding and abrasive wear behaviour of Al - 70 vol.-%Al2O3 particulate composite alloyed with Mg was examined. The composites were produced by a pressure infiltration casting technique. The composition of the matrix varied between 0 and 8 wt-%Mg, and the diameter of the Al2O3 particulates was 60 mum. Dry sliding wear tests were carried out on an unlubricated M2 quality high speed tool steel disc by a pin on disc type wear tester. Abrasive wear tests were run by rubbing the composites on abrasive Al2O3 grains. The results of the wear tests revealed that, both dry sliding and abrasive wear resistance of the composites increased with increasing Mg content in the matrix. MST/5421 Mr Ahlatci. Mr Karakas and Professor Dr Cimenoglu are in the Department of Metallurgical and Materials Engineering, Istanbul Technical University, 34469 Maslak, Istanbul, Turkey (heimen@itu.edu.tr). Associate Professor Candan is in the Technical Education Faculty, Division of Metal Casting, Zonguldak Karaehnas University 78100 Karabuk, Turkey. Manuscript received 4 February 2002: accepted 27 August 2002. (C) 2003 IOM Communications Ltd. Published by Maney, for the Institute of Materials, Minerals and Mining.en_US
dc.identifier.doi10.1179/026708303225002983
dc.identifier.endpage954en_US
dc.identifier.issn0267-0836
dc.identifier.issn1743-2847
dc.identifier.issue7en_US
dc.identifier.scopus2-s2.0-0041870671en_US
dc.identifier.scopusqualityQ2en_US
dc.identifier.startpage949en_US
dc.identifier.urihttps://doi.org/10.1179/026708303225002983
dc.identifier.urihttps://hdl.handle.net/20.500.14619/6518
dc.identifier.volume19en_US
dc.identifier.wosWOS:000184340800017en_US
dc.identifier.wosqualityQ1en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherTaylor & Francis Ltden_US
dc.relation.ispartofMaterials Science and Technologyen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectAluminum-Matrix Compositesen_US
dc.subjectFiber-Reinforced Aluminumen_US
dc.subjectDry Sliding Wearen_US
dc.subjectMg-Si Alloyen_US
dc.subjectAbrasive Wearen_US
dc.subjectMetal-Matrixen_US
dc.subjectParticle Compositesen_US
dc.subjectThreshold Pressureen_US
dc.subjectPowder Compactsen_US
dc.subjectTool Steelen_US
dc.titleEffect of magnesium addition on wear behaviour of Al-70 vol.-%Al2O3p compositesen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu