Synthesis, Characterization and Dry Sliding Wear Behavior of In-situ Formed TiAl3 Precipitate Reinforced A356 Alloy Produced by Mechanical Alloying Method
Küçük Resim Yok
Tarih
2015
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Univ Fed Sao Carlos, Dept Engenharia Materials
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
In this present study, the effect of i n-situ formed TiAl3 and AlTiSi intertnetallic phases within A356 aluminum alloy on the dry sliding wear behaviors was investigated. The TiAl3 and AlTiSi intennetallic phases were obtained by synthesizing A356 aluminum alloy containing 6% titanium for different times (1, 4, 8 and 16h). The cold pressed samples were sintered in an argon atmosphere at 530 degrees C for one hour (10 degrees C/min) and then cooled in the furnace. The sink:red samples were synthesized at 550 degrees C for different times (1, 4, 8 and 16h), and the in-situ aluminum matrix composites (AMCs) were produced. Wear tests of the AMCs were performed under 30 N load and at 1 ms(-1) sliding speed for five different sliding distances. As the result of the studies performed, formation of in-situ TiAl3 and AlTiSi intemietallic phases were detected. With the increase M synthesizing time, the porosity in the structure was found to be reduced. In addition, it was observed that the densities and hardness of the composites increased depending on the synthesizing time. The wear test results revealed that increasing hardness values of A356 + 6% Ti AMCs decreased the weight loss.
Açıklama
Anahtar Kelimeler
aluminum composites, synthesis, wear behaviat, mechanical alloying
Kaynak
Materials Research-Ibero-American Journal of Materials
WoS Q Değeri
Q4
Scopus Q Değeri
Q3
Cilt
18
Sayı
4
