Application of Taguchi method for determining optimum surface roughness in turning of high-alloy white cast iron
Küçük Resim Yok
Tarih
2013
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Elsevier Sci Ltd
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
This paper focused on optimizing the cutting conditions for the average surface roughness (R-a) obtained in machining of high-alloy white cast iron (Ni-Hard) at two different hardness levels (50 HRC and 62 HRC). Machining experiments were performed at the CNC lathe using ceramic and cubic boron nitride (CBN) cutting tools on Ni-Hard materials. Cutting speed, feed rate and depth of cut were chosen as the cutting parameters. Taguchi L-18 orthogonal array was used to design of experiment. Optimal cutting conditions was determined using the signal-to-noise (S/N) ratio which was calculated for R-a according to the the-smaller-the-better approach. The effects of the cutting parameters and tool materials on surface roughness were evaluated by the analysis of variance. The statistical analysis indicated that the parameters that have the biggest effect on R-a for Ni-Hard materials with 50 HRC and 62 HRC are the cutting speed and feed rate, respectively. Additionally, the optimum cutting conditions for the materials with 50 HRC and 62 HRC was found at different levels. (C) 2012 Elsevier Ltd. All rights reserved.
Açıklama
Anahtar Kelimeler
Ni-Hard, Machining, Tool materials, Surface roughness, Optimization
Kaynak
Measurement
WoS Q Değeri
Q1
Scopus Q Değeri
Q1
Cilt
46
Sayı
2
