INVESTIGATION OF SURFACE MORPHOLOGY OF DRILLED CFRP PLATES AND OPTIMIZATION OF CUTTING PARAMETERS

Basit Öğe Kaydı
dc.authoridnas, engin/0000-0002-4828-9240
dc.authoridERKAN, Omer/0000-0002-9428-4299
dc.contributor.authorErkan, Omer
dc.contributor.authorSur, Gokhan
dc.contributor.authorNas, Engin
dc.date.accessioned2024-09-29T16:04:50Z
dc.date.available2024-09-29T16:04:50Z
dc.date.issued2020
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, the carbon fiber reinforced polymer (CFRP) composite material was drilled using different parameters (118 degrees and 140 degrees Point Angle, 30, 60 and 90 m . min(-1) cutting speed and 0.06, 0.08 and 0.10 mm . rev(-1) feed rate). Experimental parameters were designed according to full factorial design method and the results were analyzed using Taguchi L18 experimental design. The results of the study show that the lowest surface roughness values are 0.1958 and 0.1945 mu m with the cutting speed of 90 m . min(-1) and feed rate of 0.06 m . rev(-1) in the Point angles of 118 degrees and 140 degrees, respectively. When the results of Anova analysis were evaluated, parameters (feed speed, cutting speed and end point angle) according to the effect ratios on surface roughness were formed at the rates of 41.06%, 33.13% and 5.07%, respectively. The most suitable parameters according to S/N ratios were determined using A2B3C1 factors for the average surface roughness.en_US
dc.identifier.doi10.1142/S0218625X19502093
dc.identifier.issn0218-625X
dc.identifier.issn1793-6667
dc.identifier.issue9en_US
dc.identifier.scopus2-s2.0-85082413791en_US
dc.identifier.scopusqualityQ3en_US
dc.identifier.urihttps://doi.org/10.1142/S0218625X19502093
dc.identifier.urihttps://hdl.handle.net/20.500.14619/6345
dc.identifier.volume27en_US
dc.identifier.wosWOS:000569128400010en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherWorld Scientific Publ Co Pte Ltden_US
dc.relation.ispartofSurface Review and Lettersen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectCFRP composite materialen_US
dc.subjectdrillabilityen_US
dc.subject3D surface roughnessen_US
dc.subjectTaguchi methoden_US
dc.titleINVESTIGATION OF SURFACE MORPHOLOGY OF DRILLED CFRP PLATES AND OPTIMIZATION OF CUTTING PARAMETERSen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu