Investigation of chip-back temperature during machining depending on cutting parameters

Basit Öğe Kaydı
dc.authoridBOY, MEHMET/0000-0003-2471-8001
dc.contributor.authorKorkut, Ihsan
dc.contributor.authorBoy, Mehmet
dc.contributor.authorKaracan, Ismail
dc.contributor.authorSeker, Ulvi
dc.date.accessioned2024-09-29T15:57:52Z
dc.date.available2024-09-29T15:57:52Z
dc.date.issued2007
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, measurement of the chip-back temperature developed during cutting was investigated using an embedded thermocouple into the cutting tool. AISI 1117 steel was used as the workpiece material and a K type thermocouple was used for the temperature measurement. The cutting tool used was uncoated and without chip braker and in the form of SCMW 12 M508-S217 according to ISO 1832. This cutting tool was fixed on a tool holder in the form of SSBCR 25 25 M12 and the side cutting edge angle during tests was 75 degrees as suggested in ISO 3685. The cutting tests were carried out on a Johnford TC35 CNC turning center. In selecting the cutting parameters, the reference values indicated in ISO 3685 were used. In order to locate the thermocouple on the cutting tool, a Flir Systems Therma Cam thermal camera was used. The results showed that increasing cutting speed, feed rate and depth of cut resulted in increase in the temperature at the back rake surface. However, cutting speed had the most influence on the temperature. (C) 2006 Elsevier Ltd. All rights reserved.en_US
dc.identifier.doi10.1016/j.matdes.2006.07.009
dc.identifier.endpage2335en_US
dc.identifier.issn0261-3069
dc.identifier.issue8en_US
dc.identifier.scopus2-s2.0-34249054731en_US
dc.identifier.scopusqualityN/Aen_US
dc.identifier.startpage2329en_US
dc.identifier.urihttps://doi.org/10.1016/j.matdes.2006.07.009
dc.identifier.urihttps://hdl.handle.net/20.500.14619/5055
dc.identifier.volume28en_US
dc.identifier.wosWOS:000248132000008en_US
dc.identifier.wosqualityQ2en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.language.isoenen_US
dc.publisherElsevier Sci Ltden_US
dc.relation.ispartofMaterials & Designen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjecttemperatureen_US
dc.subjectmachiningen_US
dc.subjectthermal cameraen_US
dc.subjectthermocouple methoden_US
dc.subjectcutting parametersen_US
dc.titleInvestigation of chip-back temperature during machining depending on cutting parametersen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu