Experimental and numerical analysis of the effect of cutting parameters on cutting force and chip formation in turning process

Basit Öğe Kaydı
dc.contributor.authorAkgün, M.
dc.contributor.authorDemir, H.
dc.date.accessioned2024-09-29T16:16:19Z
dc.date.available2024-09-29T16:16:19Z
dc.date.issued2021
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, the influences of cutting parameters on the main cutting force (Fc) and the chip morphology in turning of the Inconel 625 superalloy by using uncoated cutting tools are evaluated by experimental and numerical analysis. The turning tests were performed without coolant on a CNC lathe at five different cutting speeds (60, 90, 120 and 180 m/min), three different feed rates (0.12 0.18 and 0.24 mm/rev) and three different depth of cut (0.5, 1 and 1.5 mm). Kistler 9257B type dynamometer and equipment’s were used to measure the main cutting force (Fc). Finite element modelling of the cutting forces have been performed using Deform 3D software. The lowest main cutting force value was measured as 120 N in the experiments conducted at 180 m/min cutting speed, 0.12 mm/rev feed rate and 0.5 mm depth of cut. Comparing experimental and numerical analysis results, it was found that there is a deviation of approximately 12% between the experimental and numerical results of the main cutting force (Fc). © 2021, TUBITAK. All rights reserved.en_US
dc.description.sponsorshipTürkiye Bilimsel ve Teknolojik Araştirma Kurumu, TÜBITAKen_US
dc.identifier.doi10.31202/ecjse.892705
dc.identifier.endpage908en_US
dc.identifier.issn2148-3736
dc.identifier.issue2en_US
dc.identifier.scopus2-s2.0-85117711127en_US
dc.identifier.scopusqualityQ4en_US
dc.identifier.startpage897en_US
dc.identifier.trdizinid1129510en_US
dc.identifier.urihttps://doi.org/10.31202/ecjse.892705
dc.identifier.urihttps://search.trdizin.gov.tr/tr/yayin/detay/1129510
dc.identifier.urihttps://hdl.handle.net/20.500.14619/9009
dc.identifier.volume8en_US
dc.indekslendigikaynakScopusen_US
dc.indekslendigikaynakTR-Dizinen_US
dc.language.isotren_US
dc.publisherTUBITAKen_US
dc.relation.ispartofEl-Cezeri Journal of Science and Engineeringen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectCutting forcesen_US
dc.subjectFinite element analysisen_US
dc.subjectInconel 625en_US
dc.subjectTurningen_US
dc.titleExperimental and numerical analysis of the effect of cutting parameters on cutting force and chip formation in turning processen_US
dc.title.alternativeTornalama işleminde kesme kuvveti ve talaş oluşumu üzerinde kesme parametrelerinin etkisinin deneysel ve nümerik analizien_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu
TR-Dizin İndeksli Yayınlar Koleksiyonu