The influence of cutting tool coating and cutting speed on cutting forces and surface roughness in machining of austenitic stainless steels
Küçük Resim Yok
Tarih
2005
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In this study, machining tests through dry turning method were performed on two grades of austenitic stainless steels (AISI 304 and AISI 316) in order to examine the influences of cutting tool coating, cutting speed and workpiece material on the cutting forces and machined surface roughness. The cutting tools used were TiC/TiCN/TiN and TiCN/TiC/Al 2O 3 multiple layer coated cementide carbide inserts. The tests were performed at four different cutting speeds (120, 150, 180 and 210 m/min) while feed rate and depth of cut were kept constant at 0,16 mm/rev and 1,6 mm, respectively. The results showed that TiC/TiCN/TiN coated cutting tools gave lower cutting forces than did TiCN/TiC/Al 2O 3 coated ones. The cutting speed did not have any considerable influence on the cutting forces. However, the machined surface roughness values (Ra) was significantly affected by the cutting speeds used. With increasing cutting speed, the surface roughness values decreased until a minimum value is reached beyond which they increased.
Açıklama
Anahtar Kelimeler
Cutting forces, Cutting tool coating, Stainless steel, Surface roughness
Kaynak
Journal of the Faculty of Engineering and Architecture of Gazi University
WoS Q Değeri
Scopus Q Değeri
Q2
Cilt
20
Sayı
2
