The influence of cutting tool coating and cutting speed on cutting forces and surface roughness in machining of austenitic stainless steels

Basit Öğe Kaydı
dc.contributor.authorÇiftçi, I.
dc.date.accessioned2024-09-29T16:22:25Z
dc.date.available2024-09-29T16:22:25Z
dc.date.issued2005
dc.departmentKarabük Üniversitesien_US
dc.description.abstractIn this study, machining tests through dry turning method were performed on two grades of austenitic stainless steels (AISI 304 and AISI 316) in order to examine the influences of cutting tool coating, cutting speed and workpiece material on the cutting forces and machined surface roughness. The cutting tools used were TiC/TiCN/TiN and TiCN/TiC/Al 2O 3 multiple layer coated cementide carbide inserts. The tests were performed at four different cutting speeds (120, 150, 180 and 210 m/min) while feed rate and depth of cut were kept constant at 0,16 mm/rev and 1,6 mm, respectively. The results showed that TiC/TiCN/TiN coated cutting tools gave lower cutting forces than did TiCN/TiC/Al 2O 3 coated ones. The cutting speed did not have any considerable influence on the cutting forces. However, the machined surface roughness values (Ra) was significantly affected by the cutting speeds used. With increasing cutting speed, the surface roughness values decreased until a minimum value is reached beyond which they increased.en_US
dc.identifier.endpage209en_US
dc.identifier.issn1300-1884
dc.identifier.issue2en_US
dc.identifier.scopus2-s2.0-22144443817en_US
dc.identifier.scopusqualityQ2en_US
dc.identifier.startpage205en_US
dc.identifier.urihttps://hdl.handle.net/20.500.14619/10051
dc.identifier.volume20en_US
dc.indekslendigikaynakScopusen_US
dc.language.isotren_US
dc.relation.ispartofJournal of the Faculty of Engineering and Architecture of Gazi Universityen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectCutting forcesen_US
dc.subjectCutting tool coatingen_US
dc.subjectStainless steelen_US
dc.subjectSurface roughnessen_US
dc.titleThe influence of cutting tool coating and cutting speed on cutting forces and surface roughness in machining of austenitic stainless steelsen_US
dc.title.alternativeÖsteni?ti?k paslanmaz çeli?kleri?n i?şlenmesi?nde kesi?ci? takim kaplamasinin ve kesme hizinin kesme kuvvetleri? ve yüzey pürüzlülü ?üne etki?si?en_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu